Syma X5C Battery Hack guide

After one of my X5C’s battery died, I had two options: to order a new one (and wait for it 3-4 weeks) or hack a generic LiPo battery to work with the Syma X5c quadcopter, typically for me. I chose both.

As a backup plan, if my battery hack will not work, I ordered a new 600mAh battery for my X5C at a very affordable price (only US$ 4.39) from BG. I received the battery very quickly and it works perfectly with my quadcopter.

I will start with the results that were, unfortunately, very poor and it was not worth spending time and money to reproduce a hacked X5C battery.

As usual, for all DIY projects, it was fun the research and the soldering part but, the test flight was very disappointing. I couldn’t fly more than 2-3 minutes with the new battery.

Some disclaimers before you start the Syma X5C battery Hack:

Soldering irons can cause severe burns and fires!

There is a scary problem with LiPos, though they have the tendency to explode when being used, manipulated, hacked, or charged incorrectly.

I am not responsible for any damages to you or your Syma X5C quadcopter.

A not long time ago, I found an article about such a project but he used a different and bigger sized Li-Ion battery, probably from a cell phone.

The original battery of the Syma X5C is 25C.  Most of the Li-Ion batteries used for cell phones and digital cameras don’t provide enough discharging rate, usually, they are rated under 5C, because they can’t provide enough power to fly your quadcopter with full throttle.

So, I gave up using Li-Ion batteries and looked up in a local hobby store for generic Li-Po batteries. The battery must meet certain conditions:

  • 1 cell LiPo battery;
  • voltage: 3.7 volt;
  • current: 500 – 700 mAh;
  • size: must be approximately the same as the original battery, I don’t want to make any modification on the X5C body;
  • high discharge rate, unfortunately, not even on one battery was specified this parameter;
  • must be cheaper than the original Syma battery.

I found quickly a 700mAh that fits perfectly on the X5C quadcopter’s body and the price was very attractive, only $3.

Now I had everything that I needed for this hack. I started quickly because I was curious about the results.

Syma X5C battery hack step-by-step:

  • Prepare the tools (soldering irons, wire cutter, duct tape, voltmeter);
  • Remove the wires from the old dead battery;
  • Solder the wires to the new LiPo battery and make the first test. Because of the protection circuit from the battery, the power was enough only for the LED lights. When I pushed the throttle stick, everything stopped like there would have been no battery;
  • I removed the protection circuit from the battery in order to get a higher discharge rate;
  • Solder the wires back, and test again. This time the S5C ‘s motors are started without any issues;
  • Adding some duct tape to the battery to secure the wires and make a greater look;
  • Go out to make some serious tests, measuring the time of flight. That was disappointingly short: only 2-3 minutes.

In conclusion, next time, before I start something like this, I will look for a battery with a discharge rate over 20C because most of the batteries can’t handle the power-hunger of the motors.

13 COMMENTS

  1. Mikeq: if you have time to find same battery on HK, you will be surprised to see the price. Unfortunately you can not search there by type, you have to go one by one per description.
    Even on ebay you can get 4 pcs for €20 free shipping.

  2. I use:
    “Turnigy NANO-TECH pro” (NE-BA931) 750mAh, price: 7euro, fits well, work longer, but the connector doesn’t fit proper, You need to change connections by disolving on U syma (+ to – and – to +) or cut a little bit battery plug by sharp knife.

  3. “current: 500 – 700 mAh” – Ain’t current but CAPACITY !
    Current is like: 50 mA (without h(our) )
    Current is like a stream of electric power, Capacity is “how much power I can get for how long”
    (-_-)

  4. I’m intrigued by the modification, however please note that SYMA has released a New and UPGRADED battery for the X5C and X5C-1, called the “3.7V 720mAh 25C V931 F949 for Syma X5C”. They are about $12 for a set of 2, with Charger and and USB cable.
    Very importantly, the Flight Time Rating is now approximates to TEN MINUTES!
    I’ve ordered a set and will post the results at a later date.
    Stay Tuned

  5. I highly recommend NOT making Mods to LiPO batteries !!!!! They can and do catch fire or explode espeacially when if discharge or recharge rate and or wiring is wrong. NEVER bypass thermal or current safety circuits…. Leave modifying LiPO’s to the experts. these cells are wired in series and parallel networks unique to the application. MODIFYING THESE COULD COST WAY MORE, like fire, expositions. chemical burns, and a hazmat situations.

LEAVE A REPLY

Please enter your comment!
Please enter your name here